Factory Tour

1. Veneers come from the mill pre-palletized according to size, thickness, and grade.

2. Veneers are first put through a glue spreader that applies an even coat of

glue on both sides of each veneer.

3. Sixty tons of pressure for maximum pop

4. After pressing boards are stacked to cure.

5. Truckholes are drilled simultaneously for accuracy.

6. Decks are cut with an automatic shaper

7. The edges of the decks are sanded by hand.

8. SCRAPS!

9. Decks are sprayed with one coat of sealer, this raises the grains of the wood  and

seals the deck. The decks are then sanded and sprayed again with two final coats

10. The Final Product

Breaktime!