Wood
Concaves
Shapes/Sizes
Printing
Heat Transfer
Ordering
 
Our skateboards are manufactured in house from start to finish using 100% North American/Canadian Hard rock Maple. They are pressed with glue specially designed for skateboards. All of our decks are pressed using a cold-press technique with 60 tons of pressure. Three skateboards are pressed per mold, to insure concave consistency. We use the best glue available on the market, it gives the boards the best balance between pop and flexibility. We use 7plys per deck : 1/16th thickness for our core and face grade veneers in combination with cross-band veneers 1/24th thick, this combination gives the thinnest, lightest, strongest board possible. Most decks we press have a stained top veneer and 50% stained core. Decks are finished off with 3 coats of a top of the line lacquer gloss. The first coat is to seal, 2nd and third coat to give the board a glossy finish. All decks are custom made for your order and are 100% guaranteed against manufacturing defects.

Veneer patterns per deck
                            1)face 1/16”         
                            2)core 1/16”   
                            3)crossband 1/24
                            4)core 1/16
                            5)crossband 1/24
                            6)core 1/16
                            7) face 1/16”

                                                           

                         1) A core veneer has grains going length wise across the board from nose to tail.
                2) A cross-band is a veneer with grains going across the width of the board.